Suggested by another member, I added these to my cup holders. Made a big difference in appearance while having a factory look. He stated he hooked his up to the connection in the bin, however I hard wired mine into the ambient lighting.
These can be found here...
Here is a quick How-To. As always I take no responsibility if you **** it up.
Disconnect negative on battery.
Remove user control panel in center console using trim removal tool.
Disconnect connector at forward most part of compartment.
Use Positap connectors to tap into wires.
Drill 2 holes in cup holder to run the wires through.
Drill hole in side of "pass through tunnel"
Run wires from front to cup holders making appropriate connections. Tuck all wires using wire tie mounts, be sure leave slack so that the housing can slide back and forth. Reconnect connector.
Final Results...very happy with the outcome, also since this is tapped into the ambient lighting, these can be dimmed and will only turn on when the LED bar and/or headlights are turned on.