Chrysler 200 Forum banner

Recent content by Warren

  1. PO306 engine code

    Chrysler 200 Engine and Technical Discussion
    Is it odd that the Chrysler 200 is not listed in the notice?
  2. Heater core flushing solved problem

    Chrysler 200 General Discussion Forum
    After noticing no hot air on the passenger side today I did the heater core flush and it was successful. Recommend flushing in both directions and alternating back and forth and also use some compressed air in both directions. Kept getting small flakes then finally none. Also use hot water then...
  3. 2012 hardtop convertible trunk lift effort

    General Discussion
    Thanks
  4. 2012 hardtop convertible trunk lift effort

    General Discussion
    Thanks Dale
  5. 2012 hardtop convertible trunk lift effort

    General Discussion
    Hello: we bought this car used and are curious if the hard to lift trunk lid is normal. Have considered replacing both struts but wanted to be sure it would help. Trunk lid lifts completely but it is not easy as a normal car. Thanks.
  6. Inner tie rod replacement how to

    Chrysler 200 Do It Yourself Articles
    The 2 Mopar tie rod kits were purchased from Kmcautoparts on EBay for $79. The ABN tie rod tool with 3 sizes was purchased on Amazon for $39 (I am sure will need in future on other cars). The Lisle 30600 crimping tool was purchased on Amazon for $23.
  7. Inner tie rod replacement how to

    Chrysler 200 Do It Yourself Articles
    Enclosed are some pictures of my experience based on using the Mopar kits (recommended as made in the Czech Republic rather than China). It comes with detailed instructions as shown. Loosen the jam nut on the outer tie rod and paint the old inner tie rod threads up to the contact spot on the...
  8. 2013 with clunking noise

    Chrysler 200 General Discussion Forum
    I replaced by inner tie rods and that finally fixed the problem. The old ones did not have any looseness(at least when cold). I replaced them with the Mopar ones (they were made in the Czech Republic as opposed to China) and will be posting some pictures and writeup in the do-it-yourself section...
  9. 2013 with clunking noise

    Chrysler 200 General Discussion Forum
    Well I thought I fixed my clunk with plastic drain tube fix but it returns when car warmed up. So ordering new tie rod set. In my post above the brake lines are actually the power steering rack lines.
  10. 2013 with clunking noise

    Chrysler 200 General Discussion Forum
    My front end clunking noise was also the slightly loose black plastic drain tube bumping up against the brake line on the brake manifold. A tie wrap fixed that. The drain tube has a flapper on the discharge and mine needed some leaves removed. The drain tube discharge can be seen if car on a...
  11. 2012 hardtop convertible mystery bars

    General Discussion
    Ha Ha. The classic car in the picture is a 1974 Dodge Dart Sport Hang 10 edition. Still restoring but does run. 360 V-8.
  12. 2012 hardtop convertible mystery bars

    General Discussion
    Hello: We purchased a used hardtop convertible from a Ford dealer and these 2 curved bars were in the trunk. Can anyone tell me where they go as it is not obvious. It looks like they attach with some cheap plastic fasteners of which only 2 are left. I looked on the factory parts diagrams and...
Top