Chrysler 200 Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 · (Edited)
Hi folks.
I replaced front bumper bulb light to amber led and rear bumper reflect to red led by myself. It took 3hours in total.
quite consumming work.
But result is briliant.
how do you think about that?
 

Attachments

·
Registered
Joined
·
878 Posts
Looks great. Please share how you added the LEDs to the rear markers.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 · (Edited)
Looks great. Please share how you added the LEDs to the rear markers.
I ordered parts at aliexpress in china. It costs 34.35 US dollars. in total.
Maybe ebay sells same one.

First, you need to off 3 screws for opening wheel house cover(front and rear)
Second, off 2 screws holding signal light assembly.(front and rear)
Third, just replace new one then tighten 2 screws then cover the wheel cover(front and rear)

In case of rear signal, you need to do some extra work.
rear reflector is just plastic panel, so replacement led panel has to be connected to rear light.
through the rear wheel house and bumper space, you can get to the rear light assembly.
Then link lines plus to plus, minus to minus
To withdraw lines from wheel house, you have to prepare the thin and 2 feet long needle. I could get that from old window wiper.
(To get to know how lines are connected from bumper led to rear light, this video could be helpful : (117) Chrysler 200 tail lamp and bulb replacement - YouTube )

This is quite tough DIY but result would make you smile.
I had to make pics during the work. SORRY.

Hope to be helpful.
 
1 - 6 of 6 Posts
Top