Chrysler 200 Forum banner

1 - 5 of 5 Posts

13 Posts
Discussion Starter #1
I know a lot of people are looking for wiring diagrams and have been unable to locate them so I hope this helps. this is specifically for the 2013 but is consistent in 1st gen models. The center channel is not mentions because it is a parallel off of the front channel but the color is easy enough to discerned by removing the A pillars and cover.

You should be cautioned that the factory harness is not intended for excessive amounts of power. I would recommend that anyone running anything over 50 RMS per channel consider upgrading to aftermarket wiring.

2013 Chrysler 200 Audio Wiring Radio Diagram Schematic Colors

Car Radio Constant 12v+ Wire: Red/Brown @ Pin 1
Car Stereo Ground Wire: Black – Pin 12
Car Radio Ignition Switched Wire: @ Cigarette Lighter or Interface

Car Stereo VSS Speed Wire: N/A
Car Stereo Reverse Wire + : White/Green (+) @ Light
Car Stereo Dimmer Wire: N/A
Car Radio Illumination Wire: White/Purple (Parking Lights) @ Driver kick
Car Stereo Power Antenna: Gray/Orange (+) @ Pin 7
Car Radio Amp Turn On Wire: N/A

Left Front Speaker Wire (+) Positive: Gray/Purple – Pin 21
Left Front Speaker Wire (-) Negative: Gray/Yellow – Pin 22
Right Front Speaker Wire (+) Positive: Dark Green/Purple – Pin 19
Right Front Speaker Wire (-) Negative: Dark Green/Yellow – Pin 20

Left Rear Speaker Wire (+) Positive: Dark Green/Tan – Pin 8
Left Rear Speaker Wire (-) Negative: Dark Green/Gray – Pin 9
Right Rear Speaker Wire (+) Positive: Dark Green/Brown – Pin 10
Right Rear Speaker Wire (-) Negative: Yellow/Gray – Pin 11

Center Channel Speaker Wire Positive / Negative: N/A
Subwoofer Speaker Wire Positive / Negative: N/A
Radio Size: Single or Double Din
Speaker Size Front: 6×9″
Speaker Size Rear: 6×9″
Speaker Size Subwoofer: N/A
1 - 5 of 5 Posts