Chrysler 200 Forum banner
1 - 8 of 8 Posts

· Administrator
2016 Chrysler 200 S, 1998 Sebring JX
Joined
·
3,087 Posts
Some of it, but not all of it, may be there. Mopar does not offer a fog lamp kit for these, so it won't be easy.
Some accessories are difficult to add to the car because so many things are controlled by computer modules.
You could probably add a switch and hard-wiring to power the fog lights, but it wouldn't be like the factory-installed system.
Some options are very difficult to install if the car didn't come equipped with them.

Rectangle Slope Line Font Parallel



Line Rectangle Parallel Font Diagram
 

· Registered
Joined
·
105 Posts
Discussion Starter · #4 ·
I find some wire in wiring socket that going to AGS and side marker light. And have enable fog light item in alfaobd.
But my car haven't fog light switch.
If i install switch, can run fog light and power up harness wiring ?

I can't see metal pin on F91 & F92 fuse box
I need pin number diagram on 68207036AH wiring socket harness
 

· Administrator
2016 Chrysler 200 S, 1998 Sebring JX
Joined
·
3,087 Posts
The front fascia wiring harness & connector is shown here.
The wiring for the fog lamps may be incomplete if the vehicle wasn't equipped with them.
 

Attachments

  • Like
Reactions: amin.zallaghi

· Administrator
2016 Chrysler 200 S, 1998 Sebring JX
Joined
·
3,087 Posts
F91 & F92 aren't used? See PDC.pdf attachment.
If the wiring, switch & circuit is all there, the BCM should be able to operate the fog lamps.
Circuit component Font Passive circuit component Hardware programmer Parallel

KL is the Jeep Cherokee.
Font Screenshot Parallel Rectangle Electric blue
 

Attachments

· Registered
Joined
·
105 Posts
Discussion Starter · #8 ·
Don't used, i want to install lighting switch and fuse and complete harness for fog light
I can present fog light by alfaobd, install fog light, complete harness, ...
But no metal pin for fog light fuse

I may have to turn on fog light with side marker light. Easy way, cheap cost.
 
1 - 8 of 8 Posts
Top