Chrysler 200 Forum banner

1 - 5 of 5 Posts

·
Super Moderator
Joined
·
1,957 Posts
Your vehicle has an outstanding safety recall here in the United States. Unknown if that would have any impact on the codes you show.
However this is what I found with the U1477 code.
  • Check for Steering Control Module (SCM) codes
  • Faulty Transmission Control Module (TCM)
  • Transmission Control Module harness is open or shorted
  • Transmission Control Module circuit poor electrical connection
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

 

·
Moderator
2016 Chrysler 200 S, 1998 Sebring JX
Joined
·
500 Posts
These are stored codes. Have you erased them once and they came back?
What symptoms, if any are you experiencing?
Do you use the steering wheel paddle shifters and use them in a normal manner?

The U1477 may be a BCM configuration error or mismatch. Have any electrical modifications or additions been done to the car that may affect the PROXI? Are all control modules present and operating on the CAN bus?

It looks like there may be a poor connection at the RF sidemarker bulb and left DRL LED strip or you have exterior lamps out.

See attached.
 

Attachments

·
Registered
Joined
·
140 Posts
Looks like the issue with the harness, but a tsb took care of that already.
Try to reset the codes, those are stored codes.
 
1 - 5 of 5 Posts
Top