Chrysler 200 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
One of the corner's of the chrysler emblem is raised off of the steering wheel and snags loose clothing so I tried to super glue it back with no success. Do I need to use contact cement or some sort of epoxy? Cheers 🍻

57365

After seeing this photo I'm going to have to give my steering wheel a deep clean..
 

·
Moderator
2016 Chrysler 200 S, 1998 Sebring JX
Joined
·
802 Posts
I was going to advise you to remove the horn pad and set it facing up on a table with a weight on it to set the epoxy overnight, but the airbag comes off with it.
Familiarize yourself with Airbag service and handling procedures before this job. We don't anyone getting hurt or any damage to the car.
This will require a battery disconnect and pause while the storage capacitors discharge. The fasteners to remove the assembly are accessed through the left and right steering wheel spokes.
 

Attachments

1 - 2 of 2 Posts
Top